Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

Graphite provides a layer of dry lubrication that can operate in high-temperature environments.

Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings.

A figure-8-shaped groove provides a flow path for lubricant, distributing it evenly along the bearing’s surface.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

An aluminum shell adds strength.

These bronze bearings are strong, wear resistant, and excellent at handling shock loads.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

Use where high loads and speeds are not required.

Good for underwater applications, these bearings won’t swell or warp when wet.

The addition of iron and aluminum gives these aluminum-bronze bearings high strength and excellent corrosion resistance—making them suitable for use in marine and mining applications.

A reliable classic—these babbitt bearings are strong and corrosion resistant.

With no moving parts, sleeve bearings are better for dirty environments than ball and roller bearings.

Precisely shaped to fit snugly on keyed shafts, these shims align, level, and space components. Because of their tight fit, they also help components rotate in unison with the shaft.

The tapered barrel on these bushings is split on both sides, allowing them to contract more tightly around the shaft than quick-disconnect and taper-lock bushings.

Also known as Trantorque bushings, these tighten with a twist of the collar nut—no screws needed.

Made of chemical-resistant nylon, these collars are suitable for washdown applications.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Installing and removing a collar is as easy as pushing down and lifting up a clamp lever.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

One side of these collars locks down like a standard one-piece shaft collar; the other has a flush face that's flat to 0.0005", which lets you mount the collars on a shaft next to precision bearings, sprockets, and gears.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Tighten the set screw to bite into an unhardened shaft for a secure hold.

Two tapped holes on the face of these collars allow you to fasten them to gears, pulleys, and sprockets.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Secure items to either side of these collars—each half has a flat end with a tapped hole

Designed to grip evenly around your shaft, clamping couplings provide more holding power than set screw couplings without marring the shaft.

Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts.

These couplings have the gripping strength to handle higher torque than most other couplings.

Access one shaft without disconnecting the other. These rigid couplings have a solid bottom that connects the shafts and two top pieces that clamp the shafts independently.

The thick split spider on these couplings takes on twice as much torque as standard split spiders, while a set screw holds the hubs in place on your shaft. Also known as jaw couplings, use them to connect motors to pumps, mixers, and other high-torque equipment.