We will reply to your message within an hour.
With a nylon insert that grips your threaded shaft or spindle without damaging its threads, these locknuts—also called shaft nuts—hold bearings, bushings, gears, and pulleys prone to vibration tightly in place.
Often paired with spring lock washers to strengthen their hold, these retaining nuts—also known as shaft nuts—keep vibration from shifting bearings, bushings, pulleys, and gears on your threaded shaft or spindle.
Used in pairs or with another bearing retaining nut, these jam nuts—often called shaft nuts—hold bearings, bushings, pulleys, and gears in place on your threaded shaft or spindle.
Also known as trapezoidal-thread lead screws and nuts.
Multiple thread channels (also known as thread starts) create faster linear travel than lead screws with a single thread start.
Also known as single-start ball screws and nuts, these have a single thread that runs the length of the screw. They operate with more torque than fast-travel ball screws and nuts.
Multiple thread channels (also known as thread starts) create faster linear travel than ball screws with a single thread start.
Install these threaded collars on a metric lead screw to separate and position components, or use them as an end stop to limit travel.
Precision ground to create more points of contact, these roller screws and nuts are highly accurate and handle much higher loads than ball screws and nuts of the same size.
A black-phosphate finish provides mild corrosion resistance.
Made of 18-8 stainless steel, these inserts have good corrosion resistance.
These inserts come with an installation tool. Drive the keys into the surrounding material for a more secure hold than thread-locking inserts.
A distorted thread grips the screw to resist loosening.
Inserts come with a through-hole tap and installation tool.
Mount these bumpers on a threaded stud. All are reinforced with a steel core or base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines.
An interlocking steel frame in these mounts prevents collapse, even if the rubber fails.
Able to withstand temperatures up to 300° F, these grips are also corrosion- and chemical-resistant.
Wrap the split gland of these grips around ethernet cables with an RJ45 connector or other already installed cables for a water-resistant seal with your enclosure.
A rubber bushing with an oval slot resists water and provides entry for building cable, which is also known as Romex type NM-B or type UF-B cable.
Vent air from your enclosure to equalize pressure and stop condensation from forming inside while securing cords in wet environments. These polyamide grips are lightweight and resist rusting.
Secure cords installed through enclosures and panels in wet environments while protecting them against sharp bends. With a flared end that keeps cords from bending without limiting too much motion, these grips extend cord life.
Tighten the screw-down clamp for superior pull-out resistance.
Suitable for use in applications where cords are underwater—these grips are rated IP68 for protection from prolonged submersion.
Keep cords from coming loose and seal water out of enclosures in extremely cold labs and storage areas. Thanks to their plastic bushing and rubber O-ring, these grips withstand temperatures as low as -75° F.
Secure cable installed through enclosures in wet environments while venting air to protect electronics from condensation.
These grips are the most corrosion resistant of any of our submersible metal cord grips.
These cord grips are lightweight yet durable.
Attach a cord grip to cable without removing connectors and rewiring. These cord grips have a two-piece design to fit around cables with connectors.