With a nylon insert that grips your threaded shaft or spindle without damaging the threads, these locknuts—sometimes called shaft nuts—keep bearings, bushings, gears, and pulleys in place. They won’t shake loose from vibration. However, their nylon insert also means you shouldn’t use these locknuts in applications with high temperatures. Their sides are slotted, so you can tighten and loosen them with a spanner wrench or spanner socket. To reduce the total size and weight of your assembly, they have chamfered edges.

All meet international standards for bearing locknut dimensions.

Carbon steel locknuts are strong and wear resistant. Zinc-plated steel locknuts have an outer layer of zinc that prevents the steel from rusting in wet areas. Compared to stainless steel, they're stronger, more wear resistant, and less costly, but not as corrosion resistant. Avoid exposing them to salt water and chemicals. 303 stainless steel locknuts are nearly as strong as carbon steel but won’t rust in outdoor, washdown, and other corrosive environments.

When choosing your thread spacing, consider the precision of your application. The finer the threads, the more control you have when making adjustments.

For technical drawings and 3-D models, click on a part number.

Often paired with spring lock washers to strengthen their hold, these retaining nuts—also known as shaft nuts—keep vibration from shifting bearings, bushings, pulleys, and gears on your threaded shaft or spindle. They have slotted sides, so you can tighten and loosen them with a spanner wrench or spanner socket. Made of carbon steel, they’re strong and wear resistant.

Use stepped-face retaining nuts with DIN 462 spring lock washers. You can also use them in pairs or with other bearing retaining nuts as jam nuts. For the nut closer to the bearing, position the stepped face towards the bearing. All meet DIN standards for bearing lockout dimensions.

Chamfered-face retaining nuts weigh less and produce less heat than stepped-face nuts. They meet ISO 2982 (formerly DIN 981), an international standard for bearing locknut dimensions. Their sizes correspond to SKF KM series. Use them with DIN 5406 spring lock washers.

For technical drawings and 3-D models, click on a part number.