These screws are beveled under the head for use in countersunk holes.

More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.

With more points of contact than Phillips-, slotted-, and square-drive screws, you can firmly press these Torx-drive screws into wood without stripping them or damaging the recess—their threads create a tight hold.

Brass screws are corrosion resistant in wet environments and electrically conductive.

Brass screws are corrosion resistant in wet environments and electrically conductive.

A decorative rounded top provides a finished appearance. These Phillips screws are beveled under the head for use in countersunk holes. They press threads into material for a tight, secure hold.

18-8 stainless steel screws have good chemical resistance.

These steel screws are zinc plated to resist corrosion in wet environments.

Screws are beveled under the head for use in countersunk holes.

These 316 stainless steel screws have excellent resistance to chemicals and salt water.

More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.

More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.

18-8 stainless steel screws have good chemical resistance.

Because these steel screws cut threads into drilled holes as they’re turned, they require less driving torque and cause less stress on material than thread-forming screws. Also known as trim-head deck screws, they have a small flat head and slender shank to reduce the risk of splitting boards.

The neoprene-backed washer seals out contaminants.

Install these thumb-screw-head screws through a hole and thread on a retainer to keep secure—no special tools are required.

These rounded head screws have a nut that clips onto the edge of a thin panel, allowing you to mount the screw near edges. A quarter-turn locks and releases access panels, doors, and covers.

Rivet these wing head nuts into thin panels for a flush fit. They can be mounted without space between panels. A quarter-turn locks and releases access panels, doors, and covers.

Press these rounded head nuts into the backside of a panel in applications where you have access to both sides of the panel. A quarter-turn locks and releases access panels, doors, and covers.

Press these rounded head nuts into a closed-end hole or thick panel in applications where the back of the panel is inaccessible. A quarter-turn locks and releases access panels, doors, and covers.

These screws mount flush against the outer panel's surface for low-clearance applications.

Snap these screws into panels up to 0.125" thick—no tools are required for installation.

Push the plunger to secure and pull to release for quick access.