For easy positioning before a load is applied, these rotate to minimize twisting and knotting of rope and chain.

These rotate for easy positioning before a load is applied to minimize twisting and knotting of rope and chain.

Use these to adjust the position of a fitting or an object under load and minimize twisting and knotting.

The snap and split ring swing freely and pull from the center for easy alignment.

Minimize twisting and knotting of rope and chain and adjust the position of a fitting or an object under load.

Providing better load distribution and alignment than single oblong links, these reduce wear in three and four leg slings.

Also known as master and sling links, a large inner diameter provides room to attach multiple connectors or legs on a sling.

Once secured with the included locking pin, these links must be cut off to be removed.

Hammer the pin through the center to assemble these links. They’re also known as hammer locks and sling links.

Smaller than lifting oblong links, these links provide room for snaps, carabiners, and other non-lifting connectors.

The flat side allows you to connect webbing and strapping, so they lay flat and resist bunching.

Flat sides allow webbing and strapping to lay flat, so they won't slide and bunch.

Best for attaching different widths of webbing and strapping, the flat sides ensure they lay flat and won't bunch or slide.

The narrow end restricts the movement of rope and chain, and the wide end allows room to attach multiple connectors.

Also known as C-links, the notch in these links lets you slip additional links on or remove links quickly.

Often used with transport chain, these links are good for binding, tying down, and pulling loads.

A bolt fastened with a nut and cotter pin makes these shackles more secure than screw-pin shackles.

A bolt fastened with a nut and cotter pin makes these shackles more secure than screw-pin shackles.

A bolt fastened with a nut and cotter pin makes these shackles more secure than screw-pin shackles.

One end has a bolt fastened with a nut and cotter pin for a more secure connection than flush-pin connectors.

Attach a rope to the ring on the pin for remote release where access in limited. These shackles have an eye end for connecting to a hook.

Disconnect by pulling the lever or attach rope to the eye on the lever for remote release.

Indentations in the shackle body hold the head of the pin in place once fastened.

For use in low-vibration applications where the shackle remains stationary.

Minimize twisting and knotting of rope and chain.

Indentations in the shackle body hold the head of the pin in place once fastened.