Produce clean, distortion-free cuts in cable with one-handed operation.

Jaws ratchet to increase cutting pressure as you open and close the handles.

Insulated handles protect against shock from accidental contact with live electrical circuits. These cutters are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Minimize material distortion while cutting steel and stainless steel wire rope.

Keep your hands in a comfortable position so you can apply more force for cutting.

With a quick hammer blow, these cutters make cuts without squeezing or flattening wire.

Use the lever to make one-handed cuts with minimal material distortion. Cutter mounts to a workbench for extra stability and ease of use for repeated cuts.

Handle is angled 30° to keep work in sight and hands clear of the work surface. Blades are flat on one side for close-to-the-surface cuts.

Cut medium steel chain and hard steel bolts, rods, screws, rivets, nails, bars, wire, and rebar.

Make repeated cuts in hard materials with cutters that mount for stability and provides extra leverage.

Insulated handles protect against shock from accidental contact with live electrical circuits. These cutters are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

A double hinge provides high cutting force with low gripping pressure.

Made of beryllium copper that is FM approved, these cutters satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Sharpen or replace the jaws as they wear. These cutters have a double hinge that provides high cutting force with low gripping pressure.

Cut hard steel wire, nails, and small rivets close to the surface with the wide, flat jaws on these cutters.