An extra-thick steel body with carbide teeth can cut through stainless steel structural framing and electrical enclosures.

These saws reduce friction and prevent material buildup when cutting fiberglass and plastic.

The carbide-tipped teeth on these saws last up to twice as long as high-speed steel teeth.

These saws have carbide-grit-coated teeth.

Make fast bit changes—all of these bits have the same shank diameter, eliminating the need for different collets to hold each size.

Specially-designed flutes keep these bits centered as they drill, resulting in straighter, rounder holes with tighter tolerances. Also known as double-margin drill bits.

Holes in these bits allow coolant to be run through the tool for more efficient chip evacuation. Use them in CNC machines with coolant-through technology.

The parabolic spiral flutes lift chips out of the hole, reducing clogging and improving coolant flow.

The short flutes provide increased rigidity for drilling straighter holes than standard extended-length drill bits.

Also known as screw-machine and stub-length bits, these provide maximum rigidity for drilling straighter holes than jobbers'-length drill bits.

More wear resistant than cobalt steel and high-speed steel, carbide-tipped bits maintain a sharper, harder edge at high temperatures for excellent performance on abrasive material, such as plastic. Because they aren’t as brittle as solid carbide bits, they can be used in less rigid setups, such as a hand-held drill.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

Also known as A-taper bits, these fit rotary hammers with a taper-shank chuck.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

The 1/4" hex shank allows these bits to be used with standard impact drivers.

A more controlled chip removal reduces heat buildup. Use these bits on brittle material such as block and brick.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers set to rotary-only mode.

The SDS-Max shank has three deep slots and two shallow slots for use with SDS-Max-drive rotary hammers.

A built-in stop ensures repeatable drilling depths for installing drop-in anchors.

The spear-shaped point drills smoothly through glass and ceramic.