Search Results
    Cut Direction
    Cut Direction
    Right Hand
    Neutral
    Left Hand
    For Insert Shape
    For Insert Shape
    DiamondTriangle
    SquareRound
    Trigon
    Shank Width
    Shank Width
    3/8"
    1/2"
    5/8"
    3/4"
    7/8"
    1"
    1 1/8"
    Shank Height
    Shank Height
    3/8"
    1/2"
    5/8"
    3/4"
    1"
    1 1/4"
    Shank Type
    Shank Type
    SquareRound
    Rectangular
    Insert Shape
    Insert Shape
    TriangleSquare
    RoundOctagon
    Material
    Material
    Steel
    Carbide
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    End Cutting Edge Angle
    End Cutting Edge Angle
    default
    15°
    27°
    30°
    32°
    45°
    52°
    60°
    For Insert Nose Angle
    For Insert Nose Angle
    default
    35°
    55°
    60°
    80°
    90°
    Insert Holding Method
    Insert Holding Method
    Clamp with Lock Pin Screw
    Torx Screw
    Hex Screw
    Clamp
    Wedge Clamp
    Back Rake Angle
    Back Rake Angle
    default
    -13°
    -10°
    -9°
    -7°
    -5°
    Side Cutting Edge Angle
    Side Cutting Edge Angle
    default
    15°
    17.5°
    25°
    27.5°
    30°
    45°
    -5°
    -3°
    End Relief Angle
    End Relief Angle
    default
    11°
    13°
    For Insert Relief Angle
    For Insert Relief Angle
    default
    11°
    15°
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    706 Products