Use these end mills for general purpose work in most material, such as aluminum, brass, bronze, iron, and steel. The teeth are angled in two directions so you can make top and bottom chamfers without having to flip the workpiece.

In a single pass, these tools mill a precise, angled finish on the outside edge of pipe, tubes, and rods. Use them to deburr pipe and tube for butt welds or to shape rods and shafts for sliding into housings and holes. Faster and more precise than handheld scrapers, they work with screw machines, lathes, and drill presses to make reliable cuts, part after part. The six teeth distribute cutting force for a long service life. Staggered cutting edges reduce vibration for a clean cut and smooth chamfer. All are high-speed steel, a general purpose cutting-tool metal that works well on a variety of material. Attach to your machine with a shank (sold separately).

Made of solid carbide, these end mills are harder, stronger, and more wear resistant than cobalt steel for the longest life and best finish on hard material. Their extreme hardness means they are brittle, so a highly rigid setup, such as a CNC machine, is necessary to prevent the end mill from breaking. A 90° pointed tip allows them to be used for drilling as well as for slotting, profiling, and chamfering cuts. All are center cutting, allowing plunge cuts into a surface.

End mills with two flutes provide better chip clearance for high-volume, high-speed plunge, slotting, and roughing cuts. End mills with four flutes provide a finer finish and operate with less vibration when run at high speeds.

Use uncoated end mills for general purpose milling and short production runs. Use coated end mills for demanding, high-speed jobs in hard material as well as for longer production runs. They’re more wear resistant than uncoated end mills. Titanium-nitride (TiN) coated end mills create less friction than uncoated end mills, which means they last longer when run at similar speeds. Titanium-aluminum-nitride (TiAlN) coated end mills dissipate heat better than other end mills, especially at high speeds. At high temperatures, the coating creates a layer of aluminum oxide that transfers heat to the chips, keeping the tool cool, even when used without lubrication.

Made of cobalt steel, these end mills have good heat and wear resistance, so they can run at high speeds in hard material. A 90° pointed tip allows them to be used for drilling as well as for slotting, profiling, and chamfering cuts. All are center cutting, allowing plunge cuts into a surface.

Use uncoated end mills for general purpose milling and short production runs. Use titanium-nitride (TiN) coated end mills for demanding, high-speed jobs in hard material as well as for longer production runs. They’re more wear resistant than uncoated end mills, which means they last longer when run at similar speeds.

Use these end mills for general purpose work in most material, such as aluminum, brass, bronze, iron, and steel. They create dovetail slots for connecting two components with a sliding fit.

With better heat and wear resistance than high-speed steel, these cobalt steel dovetail cutters run at higher speeds and provide better performance on hard material. Use them to create dovetail slots for connecting two components with a sliding fit.

A 45° corner chamfer improves cutting edge strength, so these end mills last longer than standard square end mills when milling hard material; however they do not create as sharp of a corner. Variable spacing between the flutes reduces vibration, allowing them to provide fast cuts, smooth finishes, and long tool life.

Made of solid carbide, these end mills are harder, stronger, and more wear resistant than high-speed steel and cobalt steel for the longest life and best finish on hard material. Their extreme hardness means they are brittle, so a highly rigid setup, such as a CNC machine, is necessary to prevent the end mill from breaking. A titanium-aluminum-nitride (TiAlN) coating make these end mills good for high-temperature applications. They have a square end for milling square slots, pockets, and edges. All are center cutting, allowing plunge cuts into a surface.