The slim head fits into tight spaces and around thin fasteners.

These lightweight tools are also known as AN (Army-Navy) wrenches.

Strike the handle with a hammer to break stuck fasteners free. These are also known as slugging wrenches.

The head is offset 45° to provide additional clearance when reaching over obstructions.

Fit the narrow head into tight spaces and around thin fasteners.

The jaws on these wrenches are shaped to turn slip nuts, jam nuts, and large hex nuts.

Made of aluminum-bronze that is Factory Mutual approved, these wrenches inhibit sparking and are nonmagnetic and corrosion resistant.

Also known as a basin wrench, this tool has a pivoting head and spring-close jaws for working in tight spaces where it’s difficult to adjust a traditional wrench.

Press the lever to lock the jaw and keep these wrenches clamped on your work, leaving your hands free.

An insulated handle protects against accidental contact with live electrical circuits. These wrenches are tested to 1,000 volts to meet IEC 60900.

The adjustment knurl won't turn when the wrench is being used, preventing accidental loosening of the jaws.

Extend the handle for additional reach.

Squeeze the handles and the gripping surfaces adjust to fit your fastener and prevent slipping and stripping.

A ratchet mechanism in the head allows you to turn fasteners in tight spaces without removing and repositioning the wrench.

The handles are covered in plastic for a comfortable grip.

Turn the knob to adjust the jaws and fit a range of fastener sizes.

The opening shape makes more contact with fasteners for a better grip than standard open-end sockets. Also known as flare-nut or line wrench sockets, they're often used with flared tube fittings and fuel and hydraulic lines.

Flip these wrenches over to ratchet in the opposite direction.

Lock wrenches into these racks before taking them with you. Snap tools into the slots and twist one wrench to lock or unlock the whole set.

Mount to walls, cabinets, and other steel surfaces.

Organize your tool drawer by positioning these low-profile rails to accommodate wrenches of any length.

The head pivots to accommodate a range of diameters.

Made of aluminum-bronze that is Factory Mutual approved, these wrenches inhibit sparking and are nonmagnetic and corrosion resistant. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Fit these wrenches into slots on the circumference of collars, bearings, and other machine tool components.

Reverse the pins when you need to fit different hole sizes on the face of collars, bearings, and other machine tool components.

Hinged for adjustability, these wrenches fit a range of diameters.

Change out the pins to fit a different hole size.

These wrenches are shaped to fit round holes on the circumference of collars, bearings, and other machine tool components.

The head pivots to accommodate a range of diameters.

Open and close the jaws with one hand. Press the lever and slide the bottom jaw to the desired position; tension keeps it in place.

Grip pipe and conduit as well as tighten and loosen fittings.

Use one end as a traditional pipe wrench and the other to loosen valve wheels. These are also known as engineers’ pipe wrenches.

Made of aluminum-bronze that is Factory Mutual approved, these wrenches inhibit sparking and are nonmagnetic and corrosion resistant. They are also known as railroad wrenches.

Also known as monkey and auto wrenches, these grip large fasteners and other flat objects.