Cut soft materials such as PTFE, fiber, rubber, and cork.

When the blade gets dull, snap it off to expose a new, sharp edge. This cutter has a utility knife mounted on a radius bar.

Use these saws with a drill press to cut a variety of hole sizes in sheet metal.

These high-speed steel saws cuts through aluminum, brass, bronze, and steel.

Make clean, fast cuts in thin metal and plastic when you use one of these saws with an impact driver. The body widens at the top to prevent the saw from pushing through your workpiece.

The carbide teeth on these steel saws cut aluminum, brass, bronze, steel, and plastic sheets and last up to twice as long as high-speed steel teeth.

The carbide teeth on these saws last up to twice as long as high-speed steel teeth.

Specially designed teeth cut faster than the teeth on standard hole saws.

These saws have high-speed steel teeth.

These saws have carbide-grit-coated teeth.

These kits have saws with high-speed steel teeth and a steel body.

The saws in these kits have carbide-grit-coated teeth that cut ceramic tile, fiberglass, masonry, plastic, and composites.

Strengthened edges cut holes up to 4" dia. in fabric, leather, rubber, and soft metal. Also known as arch punches.

Attach two punch heads to the handle at the same time to punch a gasket or washer in a single strike.

Sets include common ID and OD sizes to create gaskets and washers in two strikes.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

The driver supplies eight tons of force to the hole punches in this set to make straight punches.

Create larger holes and make repeated punches with these drivers that supply 11 tons of force to the included hole punches.

A locking clamp eliminates the need to thread the punch onto the stud, making setup and disassembly quicker than with standard punches.

Punch conduit up to size 1 1/4.

Turn the handle of these punches while pushing down to punch holes in cork and rubber.

Forged steel makes the body of this punch more durable than the Economy Plier-Action Multiple-Size Hole Punch.

These medium duty tools have more than double the punching force of compact portable lever-operated punches.

Use twice the punching force of standard extended-reach punches to make holes in structural steel channels and angle iron.

Deliver nearly three times the punching force of a standard portable lever-operated punch by holding one handle and turning the other 360°.

These punches are half the size of standard portable lever-operated punches. They come with punches and dies in varying sizes.