About 25% lighter than the standard DeWalt electric circular saw, this lightweight saw reduces fatigue during prolonged cutting.

About 25% lighter than the standard Skil electric circular saw, this lightweight saw reduces fatigue during prolonged cutting.

Operate these Evolution saws at a low rpm to make smooth, burr-free cuts in metal without excessive heat or the need for coolant.

Replace frayed or cut cords.

Swap out broken or failing on-off trigger switches.

A higher air consumption rating allows this saw to work in longer bursts than the light duty air-powered portable cutoff saw. It has a durable composite handle.

The right-angle position of this saw's blade makes it suitable for both cutting and grinding with an abrasive wheel.

A high-torque motor powers these saws through tough metal, such as angle iron and tool steel. These saws must be hardwired.

Use the horizontal sliding arm to make angled cuts in wider boards than a standard miter saw can handle.

More than twice the horsepower of our standard shop-floor table saw keeps this saw from slowing down when cutting thick materials.

Support sheets of wood and plastic on the large, flat table to make straight cuts with the built-in blade.

Pins hold hose slightly bent, pulling it apart as the knife-edge blade slices a straight, smooth cut.

Specially designed teeth cut chips and transfer heat away from this saw's blade for smoother cuts in metal with less distortion than cutoff and chop saws.

Also known as dado-head blades, these are for cutting grooves in all types of wood.

Square-shaped teeth cut across the grain and with the grain (ripping) in reclaimed lumber and flooring with embedded nails.

A continuous edge on these blades produces smooth cuts. It's coated in diamond grit to cut hard, abrasive materials such as masonry, stone, asphalt, and concrete.

The blade is curved to cut arcs and circles with a radius of 15" and up.

A continuous edge on these blades produces smooth cuts.

The carbide-grit edge on these blades cuts brittle and abrasive materials including glass and fiberglass.

A razor-sharp knife edge minimizes dust and makes quick, clean cuts through foam sheets such as expanded polystyrene insulation and extruded polystyrene.

Use these blades with water or coolant to produce smoother cuts in tile than dry-cutting blades. They're also for use on glass.

Teeth are carbide tipped and designed to push chips away from the blade to prevent clogging and produce smooth cuts in aluminum sheets, tubing, and T-slotted framing.

Prevent clogging when cutting soft metal—these blades have plenty of space between the carbide-tipped teeth to allow chips to escape.

These blades have a heat-resistant coating to prevent material buildup.

Also known as rip blades, these steel blades have large, forward-angled, carbide-tipped teeth for making fast cuts.

Use these blades for occasional cutting.

A continuous edge on these blades produces smooth cuts.

The edge of the blade is segmented to cut faster than a continuous edge.

Make clean cuts in rubber and plastic hose with the scalloped knife edge on these blades.

A razor-sharp knife edge minimizes dust and makes quick, clean cuts through foam sheets such as expanded polystyrene insulation and extruded polystyrene.

A blend of tungsten carbide and diamond grits on the continuous edge of this blade cuts hard, nonmetallic materials including composites and graphite.

Teeth are carbide tipped and designed to push chips away from the blade to prevent clogging and produce smooth cuts in aluminum sheets, tubing, and T-slotted framing.

Diamond grit bonded to a segmented edge cuts through hard metal such as cast iron.

A tungsten carbide grit edge cuts through abrasive materials such as composites and fiberglass.

These blades have a continuous edge with diamond grit to cut through ceramics.

Blades and teeth are steel and treated to a Rockwell Hardness between C63 and C65 for increased wear resistance when cutting through steel and cast iron bars, rods, pipe, and tubing.

The blade edge is coated in diamond grit.