Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Use a wrench to rotate your drive shaft without marring or gouging the shaft.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

These metal collars are stronger than plastic shaft collars.

Customize the bore of these collars to precisely fit your shaft.

With larger clamping screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Two knurled sides provide micrometer-like movement for precise width adjustments.

Formed to offset the weight of the clamping screw, these collars won't wobble or vibrate when shafts are spinning—even at high speeds.

Keep these shaft collars in place by tightening their set screw into the shaft.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.

Two tapped holes on the face of these collars allow you to fasten them to gears, pulleys, and sprockets.

Secure items to either side of these collars—each half has a flat end with a tapped hole

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

To install, thread these one-piece collars onto the end of your shaft.

Install these two-piece collars square shafts.

Slide these one-piece collars onto the end of your shaft to create an end-stop for linear components.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

A mounting flange prevents movement during tightening.

Made from stainless steel or plated with nickel, these bushings resist corrosion. A mounting flange prevents movement during tightening.

Insert these nickel-plated steel bushings into the bore of your sprocket for flush or recessed mounting in wet environments.

Tighten just one set screw to clamp these bushings evenly around your shaft. The screw forces hydraulic fluid in between the double-walled sleeve, expanding the two walls against the shaft and the hub of your sprocket, pulley, or gear for a tight hold.

The screw connections on these bushings easily mate to compatible quick-disconnect sprockets and pulleys.

Connect these hangers to organize multiple lines of pipe, tubing, and conduit. The tight-fitting, santoprene body reduces vibration and prevents corrosion caused by metal-to-metal contact.

Mount these two-piece collars anywhere on an Acme lead screw without removing components.

To avoid gouging and marring your pipe while making adjustments, these collars have flats where you can grab and rotate the pipe with a wrench. They're sized precisely for a tight fit around pipe, so they're often used to support pipe passing through floors and walls.

Sized to fit snugly around pipe, these collars have flats so you can turn the collar and your pipe using a standard wrench.