Eliminating the need for step blocks or other rear support, the pivoting rocker clamps workpieces of various thicknesses.

Use with T-slot nuts or bolts and a support to secure a workpiece, vise, or fixture to a machine table.

Get everything needed for basic workholding on a machine table.

Use these blocks to support setup clamps. Fit the nonslip steps together for quick height adjustments.

The offset shape provides more clearance above the nut than standard clamps. Also known as gooseneck clamps.

Making minimal contact with the workpiece while holding securely, these clamps are good for small parts and can clamp into holes and notches.

Keep setup clamps from falling out of position when they are unclamped—the spring holds them up for quick workpiece insertion and removal. Also known as spring lifters.

Also known as toe clamps, these grip the side of a workpiece to leave the top free for machining.

Smaller than standard setup clamps, these clamps leave more usable space on a machine table when mounting a vise.

The handle locks in a horizontal position for more clearance above the clamp than standard hold-down toggle clamps.

Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

A nonreflective black oxide finish prevents glare that can interfere with machine vision systems.

Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

Often used when assembling small parts, these small clamps have the holding strength of a full-size clamp.

Bolt to the side of an object. Often used to clamp lids and covers on containers.

Weld these clamps to the side of an object or drill your own holes in the mounting plate and bolt into place.

Mount these clamps below a surface.

Replace worn screws or customize your clamps.

Suitable for production applications, these clamps have double the service life of other air-powered toggle clamps.

The base fits into round or square holes on most workholding tables for clamping anywhere on the work surface.

Fit the draw arm over a latch plate and pull the handle to clamp.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Also known as press screws, mount these clamps through a drilled hole and turn the crank to move the jaw end of the screw in and out.

When loosened, you can spin the body of this clamp around its mounting point for better access to the workpiece.

Hold workpieces of different thicknesses without adjustment.

Hold a workpiece securely from the side with minimal contact, leaving more of the workpiece free for machining.

Machine these clamps to match the contours of your workpiece and turn the screw to grip.

Install these clamps into a slot in your fixture to grip at the bottom of a workpiece edge, giving the cutting tool maximum access.

Machine these fixture clamps to match the contours of your workpieces for a stronger grip. Place the clamp between the two workpieces in a fixture and tighten the screw to extend the sides of the clamp, creating a secure hold against both workpieces.

Build these components into fixture plates, machine subplates, and tombstones for quick changes. The system clamps and locates at the same time for accurate positioning with repeatability of ±0.0005".

Mount using the holes in the base.

Secure a workpiece from the inside, leaving the outside clear for machining.

Mount to the top of your workbench.

Use these standard cam handles for most clamping applications. Push down on the handle and the head applies pressure to quickly draw two parts together for fast adjustments.

Also known as double cams, these complete cam handles have a durable, extra-large handle for clamping on fixture bases, plates, and workpieces. For fast adjustments, push down on the handle and the head applies pressure to quickly draw two parts together.