Attach one of these nonmarring rubber or plastic tips to prevent a metal holding screw from damaging workpiece surfaces.

The contact area is covered in plastic to protect soft metal and polished surfaces. Attach these tips to the end of a screw or threaded stud to apply uniform pressure on uneven and angled surfaces. Also known as toggle and swivel-foot pads.

Replace a fixed clamping surface with a swiveling pad that compensates for uneven workpieces.

All adjustments can be made from one end, allowing clamping in tight spaces.

Make quick height adjustments by turning the threaded stud.

Screw in from the top to adjust height or mount from the bottom with a hex key to set the gripping surface flush with the work surface.

The face of these grippers is angled 15°. They can be used in the jaws of lathe chucks.

Support and position workpieces and fixtures from the bottom or side. These buttons press into a drilled hole for permanent installation.

The swiveling tip supports uneven and angled surfaces.

With a larger contact surface than locating and support buttons, these pads can support large workpieces and fixtures. They're also known as rest pads.

Install these keys in a drilled and reamed hole to locate fixtures and vises on your machine table. Also known as sine keys.

To align two parts with more precision than standard spring plungers, these index plungers have a mating bushing that improves alignment and repeatability.

As the face of these plungers is pushed in, the internal spring applies outward pressure to hold a workpiece in position against stops and rails.