These rings come in a strip for less frequent reloading in auto-feed pliers.

Secure and insulate round signal wire such as data and communication wire.

These curved staples snuggly hold round signal wire such as coaxial cable and telephone wire.

Use these staples to join corrugated and solid board packaging.

These clamps must be oriented with the saddle on the long (live) end and the U-bolt on the short (dead) end. They’re also known as wire rope clips.

Use in noncritical applications, such as fencing, where the strength of a forged clamp is not required. Install clamps so the saddle is on the long (live) end and the U-bolt is on the short (dead) end. They’re also known as wire rope clips.

A cushion covering the clamp reduces vibration and wear from clamp edges. Clamps surround lines of pipe, tubing, and conduit completely while holding them close to the mounting surface.

Also known as pipe shields, these cradles provide additional support and prevent insulation from tearing when routing insulated pipe through loop hangers.

Cut as much strap as you need to hang duct, pipe, and other materials.

For centered load distribution, these clamps grip both sides of the beam and hang threaded rod from the middle.

These clamps have a fixed hanger for rigid connections.

Also known as bridle rings, routing rings have an open-eye design that allows you to quickly install wire and cable.

Hang cable and other flexible material beneath wire to prevent it from sagging and swaying. To install, hook the two ends of the ring around the wire—no fasteners required.

Mount these general purpose U-bolts into an existing bracket, or combine with a mounting plate for a secure hold at the mounting surface.

Suspend and route flat-bottomed objects such as strut channel and small duct.

For a secure hold on pipe and conduit suspended above the ground, these supports have a cushioned clamp provides a 360° grip while reducing vibration.

Mount these brackets between two studs to support copper tubing for sink faucets and other water supply fixtures.

Bolt directly to a pipe flange to suspend a run of pipe above the ground.

Hold shelves in cabinets and bookcases without standards.

Designed for both permanent connections and emergency repairs, use these buckles with banding to create your own low-profile hose clamps.

These clamps are easier to install than our Extra-Strength Low-Profile Band Clamps. Also known as center-punch clamps, they seal with a quick hammer blow to the buckle.

Clamps come packed in a box with individual compartments for each clamp size. To make sure they won’t cut into hose and tube, they have a smooth band with rolled edges.

Flip the toggle latch to install and remove these clamps in seconds.

Secure grating to your support structure.