Use these vises for reliable workholding on CNC machines.

Arrange the included pins in a series of holes to position a part at any angle and hold odd-shaped parts securely.

Made from unhardened aluminum or steel, machine these jaws to fit the contours and curves of your workpiece.

Significantly cut down on jaw changeover time—this two-part system lets you swap out jaws in less than 30 seconds. Mount the jaw plates to the vise and slide the dovetailed jaw stock in and out of the plates.

The vise body and stationary jaw are one piece for high repeatability, even under heavy clamping loads. Ground flat on the base and three sides, these vises ensure accuracy whether mounted on the base, either side, or upright.

Maintain your vise by replacing seals, springs, and other commonly worn parts.

Replace worn, broken, or lost handles.

Designed to hold your part on 4- and 5-axis milling machines, these vises provide rigid clamping while exposing five full sides of the workpiece. This allows even complex parts to be completed in a single operation. You must cut a dovetail into your material before the vise can grip it.

Keep parts in position for machining by mounting these workstops to your vise jaws.

The jaws move inward at the same time to consistently position your workpiece in the center of the vise.

Reliably hold workpieces with these basic machine vises.

The T-nut base secures the workstop into the slots of a machine table for positioning parts that extend beyond the jaws of your vise.

Sets include multiple sizes of matched pairs that are precision ground for tight tolerances on the top and bottom edges.

Instead of keeping an assortment of parallels on hand, adjust these two-piece tools to your exact height requirements.