The spiral flute design pulls chips back toward the tap, so chips won't accumulate in closed-end holes.

Sized to cut oversized threads, these tools are often used to tap holes where the threads will shrink due to heat treatment or plating.

Tap threads for left-hand threaded fasteners.

Keep chips clear while tapping. Also known as gun taps, these have spiral-point flutes that push chips ahead of the tap and out of through holes.

Create oversized threads while keeping chips clear. These taps are sized for use in holes where the threads will shrink due to heat treatment or plating.

Also known as cold-forming and fluteless taps, these press threads into material without cutting it, so no chips are created.

With a taper chamfer and bottoming chamfer at opposite ends, these taps start threads easily and are good for threading close to the bottom of closed-end holes.

These taps are made of cobalt steel for higher strength and wear resistance than standard taps. Their flutes are designed to keep chips clear, so they don't need to be reversed to prevent buildup.

To tap nickel and other hard material, these cobalt steel taps have high cutting strength. Their flutes are designed to keep chips clear, so they don't need to be reversed to prevent buildup.

Cut a range of thread sizes with a single tool. These thread mills can also produce both right-hand and left-hand threads.

With an extra-long shank, these taps have extended reach for tapping deep and hard-to-reach areas in pipe and conduit.

Also known as short-projection taps, these have fewer tapered threads at the tip than standard pipe taps, so you don't have to drive them as deep to produce full threads.