More durable and scratch resistant than liquid paint, use this dry paint with your powder coating system.

Also known as brushable ceramic, these coatings create a hard, low-friction surface. They're often used on liquid processing equipment to protect worn areas and reduce turbulence.

These coatings require an ultraviolet curing lamp to reach full strength.

Thinner than potting compounds, these rigid and wear-resistant coatings flow easily into small spaces between electrical components. Use them to secure and insulate hardware on printed circuit boards.

Shield circuit boards from flux, solder, conformal coatings, and high temperatures.

Clear enough to read through, this UV-resistant potting compound allows optimal light transmission for use with LEDs, solar cells, and fiber optics.

This paint resists heat and automotive fluids for use on engines. Match the color to your manufacturers' equipment color.

Cover scratches and wear on storage racks and carts. Match the color to your manufacturers' equipment color.

These surface fillers can be used on vertical surfaces without sagging. They repair cracked, worn, and damaged surfaces.

Knead the epoxy-coated patch and resin together to make repairs to pipes, tanks, drums, and containers in the field.

Repair small leaks and cracks in coolant tanks for commercial vehicles and industrial equipment. These surface fillers meet ASTM D3147 for their ability to stop leaks in engine cooling systems.

Repair and rebuild metal surfaces that are exposed to heat. These surface fillers withstand temperatures over 450° F.

For use in processing equipment that carries large particles 1/16" in diameter and larger, these ceramic-filled epoxies rebuild and repair surfaces exposed to abrasion from particles, such as pump housings, chute linings, and hoppers.

Mix these two-part surface fillers together to repair leaks and cracks as well as to rebuild rough spots in metal.

A high silver content allows these surface fillers to conduct electricity and heat. Use them to fill gaps and rebuild missing material on electrical connections or to assemble new components.

To stop leaks in metal tanks and equipment without draining the contents, heat the area with a heat gun or torch to melt the stick and form a permanent seal. The resulting patch can withstand pressure up to 600 psi.