Search Results
    For Collet Type
    For Collet Type
    5C
    ER-16
    ER-20
    ER-32
    100-TG
    ER-25
    ER-11
    For Use With
    For Use With
    Milling Machines
    Lathes
    Power Source
    Power Source
    Air
    Manual
    Hydraulic
    Material
    Material
    Steel
    Aluminum
    Iron
    System of Measurement
    System of Measurement
    Inch
    Metric
    Diameter
    Diameter
    3"
    4"
    5 1/2"
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Mounting Orientation
    Mounting Orientation
    Vertical
    Horizontal
    Shape
    Shape
    Hex
    Square
    Height
    Height
    3 1/4"
    3 5/16"
    4"
    Width
    Width
    4"
    5"
    Mounting Hole Diameter
    Mounting Hole Diameter
    3/16"
    3/8"
    For Maximum Workpiece ID
    For Maximum Workpiece ID
    2 3/4"
    3 35/64"
    Body Width
    Body Width
    4"
    5"
    Base Length
    Base Length
    3 7/8"
    4 1/2"
    Center Through-Hole Diameter
    Center Through-
    Hole Diameter
    5/8"
    7/8"
    For Maximum Workpiece OD
    For Maximum Workpiece OD
    2 15/32"
    3 5/32"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    113 Products