These premium nozzles are engineered for the most efficient airflow consumption.

Control consumption and noise by adjusting the airflow.

Extend these telescoping nozzles to increase your reach.

The flat nozzle tip distributes air over a wider area than focused-airflow nozzles.

Adjust airflow to control consumption and noise.

These needle-style nozzles force air to a precise pinpoint.

Nozzles are attached to a flexible tube or hose that bends and holds its shape until you reposition it.

The magnetic base mounts to your work surface and has a control valve for adjusting airflow.

Convert your blowgun to a spray gun. These nozzles spray air and liquids at the same time.

Attach one of these swivels to an air nozzle to direct air 30° left, right, up, and down.

These blowguns have a metal body.

The rubber tip won't damage parts.

Compact enough to carry with you, these guns have a built-in quick-disconnect hose coupling for easy connection to an air line.

Two inlets allow connection to air lines above or below. Use the top inlet when the blowgun is suspended from an overhead hose and the bottom inlet for bench and floor hoses.

Operate a blowgun without disconnecting your air tool—these guns fit between the tool and air hose. Good for blowing away debris after using an air-powered sander or grinder.

The included hose is ready to connect to your air supply.

Designed to reduce noise, these blowguns are quieter than similar standard guns.

Also known as air-shield and safety-shield blowguns, an outer air curtain deflects flying chips and dust while the center airstream blows away debris.

Maximize comfort and minimize strain with these lightweight guns.

The extra length lets you access hard-to-reach areas.

The most powerful blowguns we sell, these use compressed air to clean and blow debris.

Air flows out of the side of the nozzle to clean air filters, radiators, and inside recesses.

Clean surfaces without transferring dust or moisture from the air hose. These blowguns have a replaceable filter that traps particles such as rust and smoke and absorbs moisture.

These guns provide more than three times the airflow of standard static-eliminating blowguns.

Producing the same airflow as standard air knives, these are quieter and use 18% less compressed air.

Create a sheet of high-velocity air.

Also known as air wipes, these use a 360° airstream to blow off, dry, clean, and cool tubes, cables, extruded shapes, and hoses.

Attach to a blower for high-speed airflow at low pressure.

A deflector protects adjacent areas from heating. The flat shape creates a wide airflow.

Prevent accidental contact with hot nozzles.

Create a wide airflow that’s good for drying and stripping paint.

A wide spray angle provides a larger coverage area and produces a finer, more atomized spray than full-cone nozzles.

UL classified for hazardous locations, these vortex tubes convert compressed air into a stream of cold air to keep electronics within enclosures from overheating while also keeping dust and other contaminants out.

In addition to being quieter than standard enclosure-cooling vortex tubes, these stand up to washdowns and weather. They convert compressed air into a stream of cold air to keep electronics within enclosures from overheating while also keeping dust and other contaminants out.

Quietly cool electronics inside enclosures to your desired temperature while keeping out rain, snow, splashing water, and dirt.

These NEMA-rated vortex tube are designed to keep water out during washdowns.

Cool electronics inside enclosures to your desired temperature while keeping out rain, snow, splashing water, and dirt.