These steel anchors are available with corrosion-resistant finishes.

More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

These 18-8 stainless steel anchors have good chemical resistance.

The removable flat head provides a flush finish in countersunk holes.

A zinc plating provides corrosion resistance in wet environments.

More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

Install like a stud anchor—just thread the anchor, a nut, and a washer onto the end of a threaded rod, drive into a hole, and turn the nut to expand the base. Also known as rod anchors, they're often used with threaded rod to hang pipe and wiring.

These 316 stainless steel anchors have excellent resistance to chemicals and salt water.

Also known as double expansion anchors, these expand from both sides for full contact and a secure hold.

Drive these tools with a hammer to expand anchors.

These 316 stainless steel anchors have excellent resistance to chemicals and salt water.

Also known as tap-in or uni-tap rivets, these anchors are barbed to resist pull out. Made from nylon, they're chemical resistant.

Bolts are beveled under the head for a flush finish in countersunk holes.

Also known as lag shields, these anchors are designed for use with large-diameter wood screws.

These stud anchors strengthen the parts of buildings where steel framing connects to concrete. They’re also known as Nelson studs.

18-8 stainless steel anchors have good chemical resistance.

These stud-style anchors include a nut and a washer.

A pivoting toggle bar creates a strong hold.

Also known as Tapcons, use these screws in applications requiring high strength.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

Use these bits with handheld power drills, drill presses, and hammer drills.

Drive a tapping screw without removing the drill bit from your impact driver. One end holds an insert or nutdriver bit, while the other end engages with the hex-collar on the drill bit.

Also known as A-taper bits, these fit rotary hammers with a taper-shank chuck.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.

Drill holes up to 1 1/2" in diameter.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

A built-in stop ensures repeatable drilling depths for installing drop-in anchors.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

A more controlled chip removal reduces heat buildup. Use these bits on brittle materials such as block and brick.

These kits include adhesives, applicators, and mixer nozzles.

When concrete is saturated or submerged in water, use these adhesives to form strong bonds.