Patch concrete floors, stairs, and walls with these compounds.

Use these two-part compounds to patch concrete floors, stairs, and walls in cold environments, such as freezers. At room temperature, they cure faster than any of our other concrete patching compounds.

Fill cracks up to 4" deep on horizontal surfaces, such as floors and sidewalks.

Pour these ready-to-use fillers in cracks up to ½" wide and ¼" deep on horizontal surfaces to make fast, light duty repairs.

Stop active leaks of up to 50 gallons per minute in concrete, brick, and stone. These crack fillers begin to harden within seconds to create a permanent fix that won't shrink.

Repair sidewalks and factory floors in areas with heavy pedestrian traffic. They can also be used to fill minor depressions and cracks.

Fill in and shape horizontal, vertical, and overhead concrete surfaces, such as steps and columns.

Make castings and fill voids with these two-part pourable epoxies.

An easy way to make repairs in the field. Cut patches to size, peel off the backing, and press into place. Expose them to sunlight or a UV lamp and they begin to harden immediately.

Once concrete begins to set up and surface water reabsorbs, finish with a trowel to compact the top layer for a smooth, hard surface.

Slide these tools along the perimeter of poured concrete slabs to create a rounded edge for a finished appearance that resists chipping.

Create grooves in poured concrete slabs to control cracking caused by drying, settling, and freezing.

With a durable one-piece construction, these boxes have no seams or welds to crack and leak.

Improve the strength of your concrete mix by eliminating trapped air.

Make removing form-board stakes easier.

Rub these tools along the mortar between bricks for a uniform, finished appearance.

Used on ceramic, concrete, and stone floor and wall tiles, grout consists of fine sand, masonry cement, and coloring.

For use in processing equipment that carries large particles 1/16" in diameter and larger, these ceramic-filled epoxies rebuild and repair surfaces exposed to abrasion from particles, such as pump housings, chute linings, and hoppers.

These rubber-filled epoxies have excellent wear and impact resistance. Use them to repair and rebuild surfaces such as pump liners, hoppers, and vibrating feeders.

Thinner than non-sag sealants, these flow easily into cracks and have a smooth finish.

Thinner than non-sagging sealants, these flow easily into cracks and have a smooth finish.

The textured finish matches concrete surfaces.

Apply these sealants in cold temperatures, on wet surfaces, and even through running water.

Also known as neutral-cure sealants, these won't discolor copper, brass, and concrete.

These structural sealants combine the mechanical strength of an adhesive with excellent sealing properties and high flexibility.

With chemical and metal additives that are picked up by X-ray machines and metal detectors, these sealants are designed to help you comply with Hazard Analysis and Critical Control Point (HACCP) programs in food-processing facilities.

Thinner than non-sagging sealants, these flow easily into cracks and have a smooth finish.

These non-sagging sealants will not drip while hardening on vertical and overhead surfaces.

Thinner than non-sagging sealants, these flow easily into cracks and have a smooth finish.

These sealants are non-sagging, so they won't drip from vertical and overhead surfaces.

Protect concrete from mild chemicals, salts, soaps, and detergents.

Designed for marine environments, these coatings stand up to harsh chemicals, such as sulfuric acid, citric acid, and diesel fuel. They have excellent abrasion, impact, and UV resistance, as well as low hardening temperatures.

Seal freshly finished concrete to prevent it from drying too quickly during the curing process. These coatings also protect against mild chemicals, salts, soaps, and detergents.

Tiny spikes covering these rollers release trapped gas when rolled over thick self-leveling floor coatings to promote adhesion and aid in the self-leveling process.