Powerful enough to bend conduit and pipe to the angle you need with one stroke of the pump, these are for use on Schedule 40 pipe.

Bend more than one size of tubing without adjusting the bending head.

Choose these benders for short-radius conduit bending.

Repair ends of thin-wall (EMT) conduit that have been warped by cutting.

Place the tool over your tube and twist to deburr.

Power troublesome burrs off of thin-wall (EMT) conduit and attach fittings in less time than traditional hand tools. These bits have a 1/4" hex shank that fits quick-change drill chucks and power screwdrivers to quickly deburr the inside and outside edges of conduit in a single step.

With alternating cloth and nylon mesh abrasive flaps, these wheels are more flexible and produce finer finishes than all-cloth flap sanding wheels.

Sand inside pipes and tubes as well as on an angle to reach into corners and slots.

For smooth cuts and trouble-free operation, these cutters have enclosed steel bearings.

This cutter has two sets of guide wheels that ride in the corrugations for stability so you get clean, precise cuts.

A spring-loaded cutting wheel tightens as you spin these cutters around tubing without a handle to get in your way.

Turn this cutter 360° around a pipe to make a cut.

These heavy duty cutters have an iron frame for exceptional durability.

Pull one or more cables through conduit.

Made of fiberglass with a plastic tip, this tape is safer to use around energized equipment than metal fish tape.

Flexible enough for pulling wire through multiple bends, this round, stainless steel tape is stiff enough to push through tough runs without backing up.

Thicker than standard fish tape, this fiberglass tape remains stiff along its entire length for long runs of conduit and raceway. It’s nonconductive, so it’s safer to use around energized equipment than metal fish tape.

Clamp onto threaded rod, pipe, and conduit from the side to repair threads in tight spaces and where threaded ends are not exposed.

Restore any size screw, pipe, and conduit threads.

Four or six files and four handles are included in these sets.

Create external pipe and conduit threads.

Use with Ridgid Electric Pipe and Conduit Threaders and Ridgid Hand-Held Electric Pipe and Conduit Threaders to thread pipe and conduit sizes of 2-1/2, 3, 3-1/2, and 4.

Each set includes a ratchet with handle, die heads, and dies. Use them to cut NPT threads in steel pipe and conduit by hand.

Connect to a compatible ratchet or electric threader to cut external pipe and conduit threads.

Cut threads in PVC with the specially designed teeth on these high-speed steel dies.

The teeth on these high-speed steel dies are designed to cut through stainless steel.

Add or replace parts such as drive adapters, die sets, and drive bars for the Ridgid Large Size Pipe and Conduit Threader Adapter.

The cutting teeth are shaped to cut smooth threads in soft pipe and conduit material.

Also known as interrupted-thread taps, these have extra space between the cutting threads, so large chips fall without packing and high amounts of lubricant can flow between the tap and the workpiece.

Use these carbon steel taps for thread repair and occasional tapping of pipe and conduit. They can tap threads into most metal and plastic, but they have a shorter tool life than standard taps.

Also known as short-projection taps, these have fewer tapered threads at the tip than standard pipe taps, so you don't have to drive them as deep to produce full threads.

Made of cobalt steel, these taps are for use on hard pipe and conduit material, such as hardened steel.

With an extra-long shank, these taps have extended reach for tapping deep and hard-to-reach areas in pipe and conduit.