Fittings have a sleeve that bites into tubing as you tighten the nut to form a seal in applications up to 120 psi. Also known as flareless fittings.

Also known as JIC (Joint Industrial Council) fittings, these provide a tight seal on tubing that is flared to 37°.

Choose these fittings when you want the same high-quality found in our low-pressure pipe fittings, but need more strength to handle higher pressures.

The strongest steel fittings we offer, these can withstand extreme-pressure applications.

For use in noncorrosive environments, these fittings have better strength than our low-pressure iron and steel pipe fittings.

Distribute air or fluid to multiple locations from a single supply source with these manifolds. They are also known as headers.

With outlets on the side instead of on top, these manifolds have a lower profile than rectangular manifolds and fit well in cramped spaces. Use them to distribute air or fluid to three locations from a single supply source.

When you’re short on vertical space, these manifolds are a good fit—they have outlets on the side instead of on top, so they have a lower profile than rectangular manifolds. Use them to distribute air or fluid to five locations from a single supply source.

A single rounded bead grips onto hose just like a barb, but has no sharp edges that could cut or damage soft hose. Slide the beaded end into hose and secure with a clamp. Use in coolant applications up to 300 psi.

Connect these swivels to the threaded end of your dispensing hose. They rotate before and after installation as needed to prevent hose from twisting, kinking, and wearing prematurely.

Kits contain lengths of hose, nozzles, valves, and caps.

Build a custom 3/4" system to deliver coolant, cutting oil, water, or air in any direction.

Kit contains lengths of hose, nozzles, connectors, and assembly pliers.

These nozzles handle coolant pressure up to 150 psi.

The most versatile of our machine-mount coolant nozzles, these adjust from a fine mist to a direct stream and can deliver coolant in any direction. Max. pressure is 100 psi.

Press these nozzles into unthreaded holes.