Choose an actuator and contact block to make your own 30 mm switch.

Choose an actuator and contact block to make your own 22 mm plastic switch.

A quick push is all it takes to actuate these switches.

A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

Mount these switches in panel cutouts where changing a battery or routing wires might be difficult—they power themselves when you push the button.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

Actuate these switches with the push of a button. Their buttons are distinct colors to help you quickly spot switches without labels.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Change the cover on these switches without replacing them entirely—they come with seven snap-on covers in different colors. The colors help you quickly identify switches without labels.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Install in 16 mm dia. cutouts.

Immediately cut power with a single push.

Grip and twist a lever to turn these switches on or off—they’re designed to prevent accidental actuation. Install them into standard-sized panel cutouts.

Prevent accidental actuation from bumps or vibration—these switches require you to grip and twist the lever to turn the switch. The contact block and actuator are all one piece, so they won’t separate in high-vibration applications.

Prevent accidental actuation from bumps or jostles—these switches require you grip and twist a lever to turn them on or off. Install them in 30 mm dia. cutouts.

Thanks to their ability to handle higher current than switches with contact blocks, these switches are often found in applications from large motors to warehouse lighting systems.

Install these key switches in 30 mm dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

Sized for 22 mm dia. panel cutouts, these switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Install these switches inside an enclosure to prevent it from opening when power is on—turn the switch to disconnect power and release the door.