These tanks have drain ports on the bottom to remove condensation. All other ports can be used as inlets or outlets in any configuration.

Steel tanks are primed or powder coated for exterior corrosion resistance.

Note: Per ASME code, all tanks are water tested. Those made without a corrosion-resistant coating or material will have rust on the interior.

Provide extra protection for products that require double-wall containment, such as diesel and waste oil, solvents, and antifreeze. The tank's second wall forms a spill-control compartment that holds 110% of the primary compartment's storage capacity. They have an opening for venting in the primary compartment, an opening for leak detection in the secondary compartment, and two openings for emergency venting in the primary and secondary compartments.

When spills happen, these pallets contain the mess. They’re made of polyethylene, so they won’t degrade from most chemicals. They also meet EPA standards for liquid storage. To minimize potential leak points, these pallets are built without a drain. You’ll need to pump or clean out liquids after a spill—remove the grating to access the interior.

When choosing a pallet, consider the surface area and capacity you need. For number of 55-gallon drums gives you a sense of the surface area of your pallet, while capacity tells you how much liquid it can hold. When used correctly, these pallets meet EPA 40 CFR 264.175. Choose a pallet that’s large enough to hold either 10% of the total capacity of all the containers on it or the full capacity of the largest container—whichever is greater.

Ramps—Add a ramp to wheel drums onto your pallet with a hand truck.

Tanks have drain ports on the bottom to remove condensation. All other ports can be used as inlets or outlets in any configuration.

Note: Per ASME code, all tanks are water tested and will have rust on the interior.