Use these sleeves with compression nuts and fittings to create a strong seal on copper tubing.

Also known as instrumentation fittings, these are made to tighter tolerances than standard compression fittings. They are compatible with Parker CPI fittings.

Solder these fittings to tubing for a permanent, leak-tight connection. They are also known as sweat fittings.

The flared end of the fitting nests inside the fitting body, providing extra support to the tubing. Fittings are also known as inverted 45° flared fittings.

No sleeve is required to assemble these fittings, which makes for a faster, more convenient installation compared to 37° flared fittings. They are also known as refrigeration and SAE fittings.

Also known as JIC (Joint Industrial Council) fittings, these connect to tubing that is flared to 37°. They can handle higher pressures than 45° flared fittings.

Create a leak-tight seal without using heat or solder. Slide copper tubing into a press-connect fitting and use these tools to crimp the connection.

Made of plastic, these fittings are lightweight compared to our brass push-to-connect fittings.