We will reply to your message within an hour.
Couple these adapters with a cord that matches your outlet and length requirements to run DC-powered electronics.
Plug these adapter cords into a standard outlet and they change AC voltage to DC voltage.
To run DC-powered lab and medical equipment from your outlet, add a power cord with the plug style and length you need. These adapters meet strict IEC, UL, or ANSI/AAMI standards for use with medical devices.
Swap the plug to match the outlet of the region you’re in instead of using separate cords for each country. These adapter cords convert AC voltage to power DC electronics.
Connect multiple M8 and M12 cords to create a network between equipment. These blocks are often used to send signal and power to proximity switches and sensors.
Use these cords with hydraulic and air-powered valves, motors, pumps, and pressure switches. They have a solenoid valve socket on one end and an M12 threaded plug on the other.
Made with industry standard barrel-style ends, these connectors carry DC power between electronic devices and power supplies.
Power hydraulic and air-powered valves, motors, pumps, and pressure switches.
Change the M8 8-pin connection on your Schunk gripper to wire leads for hardwiring robots that don’t have an M8 8-pin connection.
These heaters require a separate temperature switch or controller to regulate heat output.
Wrap the flexible fiber heating element around small-diameter pipes and tubes or pack it into tight spaces.