Since these heaters continually supply the same wattage regardless of the surrounding temperature, they’re less prone to power surges than self-regulating heaters. All require a temperature switch or controller (sold separately) to regulate heat output. They’re often used to maintain liquid temperature and viscosity and provide freeze protection in pipe and tube systems. To prevent burnout, heaters must not be overlapped and must be in full contact with the surface being heated. All have a plastic cable cover for corrosion resistance and durability. They are FM approved for hazardous locations. A power-connection/termination kit (sold separately) is required.

Power-connection/termination kit (sold separately) includes a junction box and a three-point DIN-mount terminal block. It also includes adhesive, an end cap, and a power-connection cover.

Termination kit (sold separately) includes adhesive, an end cap, and a power-connection cover.

LED termination kit (sold separately) has a high-visibility green LED to indicate when the heater is on. It also includes adhesive, an end cap, and a power-connection cover.

Note: Only install these heaters in accessible locations; do not install them behind walls, underground, or in other difficult-to-access areas. Use fiberglass tape or heat-transfer putty to install them directly on surfaces that are free of dirt, grease, and rough edges. Do not use electrical tape, duct tape, metal bands, or wire. To prevent heat loss and protect heaters from moisture and corrosion, wrap them with fiberglass insulation.