These counters have mounting holes and a base plate for securing to a wall or work surface.

These counters have mounting holes and a base plate for securing to a wall or work surface.

For quick installation, these counters fit into standard DIN panel cutouts.

For quick installation, these counters fit into standard DIN panel cutouts.

Precisely count rotations by attaching these counters to clutches, couplings, rotors, or other rotating shafts.

The digits displayed on these counters are visible up to 100 ft. away.

The digits displayed on these counters are visible up to 100 ft. away.

Count metallic objects as they touch or pass within 0.059" of the built-in sensor.

Slot these counters into a control or electrical panel cutout.

Send a signal to another device when the counter reaches a set point. The signal can start/stop a process or trigger an alarm.

Record the running time of machines and vehicles that vibrate while operating.

Wire these counters/ratemeters to an electrical pulse-emitting switch, sensor, or encoder to count input while tracking rates in units such as gallons per minute.

Measure sheets, rolls, and strips using these wheels and their attached counters.

Feed wire through the wheels inside the included counter to take measurements.

Roll these wheels along a surface to measure distances up to 99,999 feet.

Count down to zero or count up to as much as 24 hours with these digital timers.

Quickly view starts and finishes on a digital screen.

Measure the total flow volume of water in your system.

The enclosure meets NEMA 4X to protect these totalizers from dust, washdowns, and corrosive liquids.

These totalizers meet NSF/ANSI Standard 61 for use in drinking water systems.

With a display that can be mounted up to 1,000 feet from the body, these totalizers are often installed in hard-to-access areas and remote locations.

More than twice as accurate as standard totalizers for fuel, these are rated for ±2% accuracy.

Install this totalizer on your grease gun to accurately measure grease dispensing and reduce waste.

Determine the flow rate and total flow volume of water with the same meter.

For secure connections in large pipelines with high flow rates, these flowmeter/totalizers have flanged ends.

With a display that can be placed up to 25 feet from the sensor, these flowmeter/totalizers are often used in hard-to-access areas.

The remote sensor with a cable lets you take pH readings in hard-to-reach areas.

Check your system for contaminants with this meter that detects total dissolved solids (TDS) in aquaculture solutions, wastewater, and other dirty liquids.

View conductivity readings of wastewater, boiler condensate, aquaculture solutions, and other dirty liquids up to 3 feet from the remote sensor to indicate the concentration of salts, nutrients, chemicals, and other substances.

Check the oxygen levels of water and other clean liquids in harsh field conditions. This meter has a housing that meets IP67 for complete resistance to dust and protection from temporary submersion.

Since these meters float and have a housing that meets IP67, they won’t be damaged by temporary submersion and have complete resistance to dust. They detect total dissolved solids (TDS) in water, hydroponic solutions, and other clean liquids to determine contaminant levels.

The remote probe on a 3-ft. cable limits your exposure when taking total dissolved solids (TDS) measurements to determine contaminant levels in aquaculture solutions, boiler condensate, contaminated water, and other dirty liquids.

Commonly used to test environmental samples, boiler condensate, wastewater, and other dirty liquids for contaminants, this bench-top meter determines the total dissolved solids (TDS) in a solution.

Check the pH and conductivity of water and other clean liquids with one bench-top device.

Test three different water-chemistry measurements in dirty, wet conditions. These meters have a housing that meets IP57 for good resistance to dust and protection from temporary submersion.