Designed to grip evenly around your shaft, these couplings provide more holding power than set screw couplings without marring the shaft.

Designed to grip evenly around your shaft, these couplings provide more holding power than set screw couplings without marring the shaft.

Also called double-loop couplings, these have a flexible center that reduces vibration and compensates for high parallel and angular shaft misalignment.

With a bellows between two hubs, these couplings handle all types of misalignment and are good for precision stepper and encoder motion-control applications.

An acetal plastic spacer at the center of these couplings insulates bearings, encoders, and other shaft components from stray electric current. Use them with servomotors, which sometimes generate current that travels down the shaft and can damage circuit boards, interfere with readings, and cause wear on bearing raceways.

The thick split spider on these couplings takes on twice as much torque as standard split spiders, while a set screw holds the hubs in place on your shaft. Also known as jaw couplings, use them to connect motors to pumps, mixers, and other high-torque equipment.

Each hub includes a set screw, which bites into your shaft to hold the coupling in place.

Often used in electronics manufacturing facilities and other extra-clean environments, these shaft couplings are cleaned and individually bagged to keep out contaminants.

Designed to grip evenly around your shaft, clamping couplings provide more holding power than set screw couplings without marring the shaft.

These couplings have the gripping strength to handle higher torque than most other couplings.

Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts.

These U-joints are made of steel or zinc.