System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter | Show |
---|
|
For Shaft Diameter For Shaft Diameter | Hide |
---|
For Shaft Type For Shaft Type |
---|
![]() | Keyed |
Construction Construction |
---|
|
For Motion Type For Motion Type |
---|
|
Material Material |
---|
|
Set Screw Material Set Screw Material |
---|
|
Component Component |
---|
|
Set Screw Type Set Screw Type |
---|
![]() | Hex Socket |
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Number of Set Screws Included Number of SetScrews Included |
---|
|
Clamping Screw Material Clamping Screw Material |
---|
|
Clamping Screw Type Clamping Screw Type |
---|
|
Fabrication Fabrication |
---|
|
Number of Clamping Screws Included Number of ClampingScrews Included |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
About Shaft Couplings
More
Set Screw Flexible Shaft Couplings


Each hub includes a set screw (unless noted), which bites into your shaft to hold the coupling in place. Also known as Lovejoy® couplings, these three-piece couplings have a spider-shaped cushion between two hubs to reduce shock and handle minor shaft misalignment.
Buna-N spiders provide good vibration damping and chemical resistance. Hytrel spiders provide fair vibration damping and excellent chemical resistance.
For technical drawings and 3-D models, click on a part number.
Two-Piece Shaft Coupling Bridges

When your shafts are not close enough to use standard couplings, these have the length to bridge the gap. Install them anywhere on a shaft without removing components or having access to the ends of the shaft. Tighten the clamping screws to secure. Good for high-torque applications, rigid couplings connect two shafts that are aligned, allowing for no relative movement between the shafts.
For technical drawings and 3-D models, click on a part number.
For Shaft Dia. | Overall Lg. | OD | Max. Speed, rpm | Max. Torque, in.-lbs. | For Motion Type | Each | |
Cast Iron | |||||||
---|---|---|---|---|---|---|---|
For Keyed Shafts | |||||||
2 3/16" | 9 5/16" | 5 3/4" | 3,180 | 12,000 | Forward/Reverse, Start/Stop, Continuous | 0000000 | 0000000 |