Designed to grip evenly around your shaft, these couplings provide more holding power than set screw couplings without marring the shaft.

Able to handle high twisting forces as well as misalignment, these couplings are good for high-performance servomotor applications.

Connect shafts and ball screws to high-speed servomotors and stepper motors—these shaft couplings handle four times more speed than standard servomotor couplings.

The thick split spider on these couplings takes on twice as much torque as standard split spiders, while a set screw holds the hubs in place on your shaft. Also known as jaw couplings, use them to connect motors to pumps, mixers, and other high-torque equipment.

Safely connect slightly misaligned shafts near food lines—the spider on these couplings contains metal, so it’ll trigger a metal detector if a piece frays off and contaminates your batch.

Designed to grip evenly around your shaft, clamping couplings provide more holding power than set screw couplings without marring the shaft.

These couplings have the gripping strength to handle higher torque than most other couplings.

Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts.

Stainless steel hubs allow these U-joints to handle harsh environments.