Each hub includes a set screw, which bites into your shaft to hold the coupling in place.

The thick split spider on these couplings takes on twice as much torque as standard split spiders, while a set screw holds the hubs in place on your shaft. Also known as jaw couplings, use them to connect motors to pumps, mixers, and other high-torque equipment.

Each hub includes a set screw, which bites into your shaft to hold the coupling in place.

Also known as Schmidt couplings, these handle higher angular misalignment than other three-piece couplings. Good for applications with varying shaft misalignment, they're commonly used with conveyor rollers and roller feeds in printing and packaging machines.

Made with lightweight nylon sleeves, these gear couplings require less energy to move than other high-torque flexible couplings. They compensate for parallel, angular, and axial misalignment.

With a rugged roller-chain design, these couplings provide excellent torque and angular misalignment capacities.

Magnetic force transfers torque from one half of these couplings to the other; there’s no contact between the parts, so they won’t wear. Couplings compensate for angular and parallel misalignment.

When one of your shafts is undersized from wear, oversized from coatings, or uncommonly sized, machine one end of these couplings to fit. They clamp around your shafts for a secure hold that won’t cause damage.

When you need a strong hold and even grip on shafts that are oversized due to finishes, undersized from wear, or uncommonly sized, we’ll make a coupling for you that fits just right. These couplings clamp around your shafts to prevent marring them.

Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts.

When your shafts are not close enough to use standard couplings, these have the length to bridge the gap.

Support the weight of a motor and transfer torque to another shaft at the same time with these couplings.

Stainless steel hubs allow these U-joints to handle harsh environments.

These joints are made of steel.

Reduce the diameter of your shaft while adding length.

Protect shafts, motors, and gear boxes from damage that’s caused by torque overload from machine jams and emergency stops.

Often used in automated systems, these couplings are air actuated so you can adjust the torque during operation.

Often used in automated systems, these couplings are both air actuated and remotely adjustable, so you can adjust the torque setting even during operation.