About Rod Ends
More
About Shaft Collars
Shaft collars are useful for holding and positioning components on a shaft. They can also serve as mechanical stops and stroke limiters.
More
Threaded Shaft Collars
To install, thread these one-piece collars onto the end of your shaft. They clamp evenly around the shaft to create a strong, mar-free hold. Tighten the clamping screw to secure.
Black-oxide steel collars have some corrosion resistance. 303 stainless steel collars have excellent corrosion resistance.
Ball Joint Rod Ends
Made of steel, these rod ends generally handle higher loads than stainless steel, aluminum, and nylon rod ends. They don’t come lubricated, so you’ll need to lubricate during installation and on an ongoing basis.
Zinc-plated steel rod ends provide moderate corrosion resistance.
| Shank Thread Size | ID | Max. Ball Swivel | O'all Wd. | O'all Thick. | Shank Center Lg. | Shank Thread Lg. | Static Radial Load Cap., lbs. | Material | Choose a Shank Thread Direction | Each | |
Ball Joints | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| 2"-12 | 2" | 6° | 5" | 1 3/4" | 8" | 4 1/2" | 153,500 | Zinc-Plated Alloy Steel | 00000000 | 0000000 | |
Internally Threaded Ball Joint Rod Ends
Made of steel, these rod ends generally handle higher loads than stainless steel, aluminum, and nylon rod ends. They don’t come lubricated, so you’ll need to lubricate them during installation and on an ongoing basis.
Zinc-plated steel rod ends provide moderate corrosion resistance.
| Shank Thread Size | ID | Max. Ball Swivel | O'all Wd. | O'all Thick. | Shank Center Lg. | Shank Thread Lg. | Static Radial Load Cap., lbs. | Material | Choose a Shank Thread Direction | Each | |
Ball Joints | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| 2"-12 | 2" | 6° | 5" | 1 3/4" | 8" | 4" | 153,500 | Zinc-Plated Alloy Steel | 00000000 | 0000000 | |
Rod Alignment Couplers
Increase cylinder life by fixing alignment problems between air or hydraulic cylinders and driven components. Couplers have a threaded end that moves to compensate for the angle of misalignment, reducing wear on cylinder bearings and seals. Couplers have a male and female end.
Thread Size | Body Material | OD | Lg. | Max. Pull Force, lbs. | Each | |
5° of Misalignment | ||||||
|---|---|---|---|---|---|---|
| 2"-12 | Steel | 5" | 8 5/8" | 77,450 | 000000 | 0000000 |