Use these fittings in extreme-pressure conditions up to 15,000 psi.

Their small size makes these miniature fittings a good choice for cramped, confined spaces.

Fittings have sharp barbs that grip push-on hose with no clamps or ferrules required. The more you pull on the fittings, the tighter the hose will grip. Use in low-pressure hydraulic applications up to 350 psi.

A single rounded bead grips onto hose just like a barb, but has no sharp edges that could cut or damage soft hose. Slide the beaded end into hose and secure with a clamp. Use in coolant applications up to 300 psi.

The flared end of the fitting nests inside the fitting body, providing extra support to the tubing. Fittings are also known as inverted 45° flared fittings.

Instead of a metal sleeve (ferrule), these fittings have a rubber sleeve that cushions tubing and absorbs vibration to maintain a tight seal, even when connected to large pumps.

Also known as JIC (Joint Industrial Council) fittings, these provide a tight metal-to-metal seal on steel tubing that is flared to 37°.

A built-in shut-off valve stops airflow when the fittings are disconnected from tubing.

A 316 stainless steel body gives these fittings the best corrosion resistance of all our metal push-to-connect tube fittings.

Ball bearings allow these fittings to rotate 360°, even after they are tightened. They have a special seal that reduces friction to allow for continuous rotation.

Use at pressures up to 150 psi.

Minimize leaks in your line—these fittings have a single barb that creates a smooth clamping surface for extra-tight connections.

Color-code fittings for easy identification. These aluminum fittings have good corrosion resistance, but are lighter in weight than brass.

Made of stainless steel, these fittings have better corrosion resistance than brass fittings.

Made of stainless steel, these couplings stand up to wet environments.

Fittings have a barb that grips onto tubing. Use in applications up to 120 psi.