These platforms are nonconductive fiberglass. Configure them to fit your application. For good slip resistance, platforms are perforated and stairs are grit coated.

First, determine how high your work platform needs to be and choose the stairs that accommodate that height. Then, choose a platform section based on the desired length. Next, choose platform supports that correspond to the height of your stairs—each end of the platform must be supported by a platform support. Finally, choose handrails for the stairs and platform. Assembled work platforms should be secured to a supporting surface.

Platform handrails have built-in toeboards.

Platform supports are required at each end of a platform section. Supports must be used every 60", so 120" long platform sections also require a support in the middle.

Note: Work platforms meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.

Set at a steeper angle than our other crossover bridges, these bridges require less floor space. Use them to walk over conveyors, machines, and pipes.

You are responsible for adhering to local, state, and federal safety codes, including OSHA.

Note: The number of steps listed is the number of steps on each side including platform.

Serrated steps offer excellent slip resistance and an open-grid design that allows dirt and liquids to fall through.

Diamond-plate steps also provide slip resistance but do not allow anything to fall through.

Aluminum is a good choice for damp areas and outdoor use. Set at a steeper angle than our other crossover bridges, these bridges require less floor space. Use them to walk over conveyors, machines, and pipes.

You are responsible for adhering to local, state, and federal safety codes, including OSHA.

Note: The number of steps listed is the number of steps on each side including platform.

Serrated steps offer excellent slip resistance and an open-grid design that allows dirt and liquids to fall through.

Diamond-plate steps also provide slip resistance but do not allow anything to fall through.

Use these bridges to walk over conveyors, machines, and pipes.

Note: The number of steps listed is the number of steps on each side including platform.

Serrated steps offer excellent slip resistance and an open-grid design that allows dirt and liquids to fall through.

Diamond-plate steps also provide slip resistance but do not allow anything to fall through.

Note: Crossover bridges meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.