Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts in aluminum, iron, stainless steel, and steel.

Made of premium grade abrasives, these wheels are strong and thick for making notches in aluminum, iron, stainless steel, and steel.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts.

Made of a combination of ceramic alumina and zirconia alumina, these wheels last up to ten times longer than standard cutoff wheels when cutting hard metal such as Inconel, Hastelloy, and tool steel.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts.

Two layers of fiberglass mesh reinforcement give these wheels at least three times the life of standard cutoff wheels when cutting metal such as aluminum, iron, stainless steel, and steel.

Run these high-density aluminum oxide wheels at higher speeds than standard cutoff wheels to make quick cuts in aluminum, iron, stainless steel, and steel.

For quick cuts in stainless steel, run these high-density zirconia alumina wheels at a higher rpm than standard cutoff wheels.

An extra-fine layer of fiberglass mesh reinforcement allows these wheels to make smoother cuts than standard bench-grinder cutoff wheels when cutting metal such as aluminum, iron, stainless steel, and steel.

Made of diamond abrasive, these wheels cut ceramics, tile, and other abrasive materials.

A ceramic alumina abrasive cuts through stainless steel.

Use these clog-resistant wheels to make quick cuts in soft metal such as aluminum, brass, and copper.

These wheels are reinforced with fiberglass mesh and designed to last longer than standard wheels when cutting ductile cast iron.

Make cuts in hard, brittle materials such as firebrick, stone, and concrete.

These wheels are designed to cut stainless steel. They are reinforced with a layer fiberglass mesh.

These non-reinforced aluminum oxide wheels create the nearly polished finish required for testing metal.

Designed to cut sheet metal.

These wheels have a blend of aluminum oxide and silicon carbide abrasives for cutting ductile cast iron.

These steel wheels have a diamond grit edge for making cuts in abrasive materials such as ceramic and tile.