Clear All
    Cut Style
    Cut Style
    Show
    Rounded-Edge Square
    System of Measurement
    System of Measurement
    Inch
    Number of Flutes
    Number of Flutes
    23
    4
    Material
    Material
    Carbide
    Cobalt Steel
    Shank Diameter
    Shank Diameter
    default
    1/8"
    3/16"
    1/4"
    5/16"
    3/8"
    7/16"
    1/2"
    5/8"
    3/4"
    1"
    End Mill Type
    End Mill Type
    Center Cutting
    Number of Milling Ends
    Number of Milling Ends
    1
    Flute Type
    Flute Type
    Spiral
    Shank Type
    Shank Type
    Round
    Helix Angle
    Helix Angle
    30°
    35°
    Individual/Set
    Individual/Set
    Individual
    Flute Spacing
    Flute Spacing
    Equal
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    For Maximum Hardness
    For Maximum Hardness
    Rockwell C62
    Neck Diameter
    Neck Diameter
    0.175"
    0.23"
    0.292"
    0.355"
    0.48"
    0.605"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    137 Products