For longer tool life and a better finish in general purpose milling applications, these solid carbide end mills are harder, stronger, and more wear resistant than high-speed steel and cobalt steel end mills.

A 45° corner chamfer improves cutting edge strength, so these end mills last longer than standard square end mills when milling hard material; however they do not create as sharp of a corner. Variable spacing between the flutes reduces vibration, allowing them to provide fast cuts, smooth finishes, and long tool life.

Serrations along the cutting edge act as chip breakers, so these end mills can remove large amounts of material at high speeds.

Remove large amounts of material quickly without sacrificing tool life. These end mills have serrations on the cutting edge and variable spacing between flutes to reduce cutting time and vibration in high-volume jobs.

Variable spacing between the flutes reduces vibration, allowing these end mills to provide fast cuts, smooth finishes, and long tool life. They have a high helix angle and a wear-resistant coating for excellent shearing and chip removal in stainless steel and titanium.

Serrations along the cutting edge act as chip breakers, so these end mills can remove large amounts of material at high speeds. They have a high helix angle and a wear-resistant coating for excellent shearing and chip removal in stainless steel and titanium.

Variable spacing between the flutes reduces vibration, allowing these end mills to provide fast cuts, smooth finishes, and long tool life. They are uncoated for use in soft material, such as aluminum, brass, and bronze.

Alternating layers of titanium-nitride (TiN) and titanium-aluminum-nitride (TiAlN) coatings give these end mills the hardness, wear resistance, and temperature resistance needed for cutting tool steel, hardened steel, and iron.

Use these end mills for short runs and general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel.

Commonly used to make keyways in rotary shafts, these tools have a -0.0015" to 0.0000" mill diameter tolerance for creating a precise fit.

With better heat and wear resistance than high-speed steel, these cobalt steel end mills can run at higher speeds and provide better performance on hard material, such as cast iron, hardened steel, titanium, and tool steel.

A higher helix angle means these end mills clear more chips than other roughing cobalt steel end mills, making them better for milling aluminum, brass, and bronze. Serrations along the cutting edge act as chip breakers, so they can remove large amounts of material at high speeds.

Use these tools with low-horsepower, manual milling machines. They have clamps for holding inserts that do not have a mounting hole. Replaceable carbide-insert end mills reduce waste and cost in high-volume jobs—when the cutting edges dull, replace the carbide inserts instead of the entire end mill.

Offering two times the life of a standard carbide end mill, the end mills in these sets have two milling ends so you can switch to the opposite end when one end wears out. Made of solid carbide, they're harder, stronger, and more wear resistant than high-speed steel for the longest life and best finish on hard material.

For general purpose milling in most material, the end mills in these sets have one milling end and a standard shank.

Create square slots, pockets, and edges in wood.

The aluminum-titanium-nitride (AlTiN) coating on these bits resists heat and wear when cutting steel and stainless steel. They have a square cut style for creating slots, pockets, and edges.

With a diamond coating, these bits resist wear when used on ceramics and other highly abrasive material. All have a square cut style to create slots, pockets, and edges.