Clear All
    For Use On
    For Use On
    Show
    Fiberglass
    System of Measurement
    System of Measurement
    Inch
    Metric
    Wire Gauge
    Letter
    Number of Flutes
    Number of Flutes
    1
    2
    3
    4
    5
    6
    8
    10
    Individual/Set
    Individual/Set
    Individual
    Set
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Countersink Angle
    Countersink Angle
    default
    60°
    82°
    90°
    100°
    120°
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Cutting Angle
    Cutting Angle
    30°
    60°
    82°
    90°
    120°
    Flute Spacing
    Flute Spacing
    Equal
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    4,391 Products