A lightweight, nonmagnetic, and nonconductive alternative to metal springs, these plastic springs are better for corrosive environments and applications where metal springs cannot be used, such as in sensitive imaging equipment and machines where stray electrical current may cause damage.

Each hub includes a set screw, which bites into your shaft to hold the coupling in place.

Press these grommets into a hole to add cushion on both sides.

Easier to install than grommets, push these bushings through your mounting hole to dampen vibration. Use them with a vibration-damping washer to isolate vibration.

Use these in place of normal washers to damp vibration and cushion your joint.

Made of fiber-reinforced PVC, these pads endure exposure to corrosive chemicals, such as cleaning solvents, chlorine, and hydrochloric acid.

Diffusers come with a collar and damper already in place for simple installation.

Reflect sound and block noise from traveling to other parts of your facility.

Actuators automatically switch between incremental and proportional control to adjust dampers to regulate airflow.

All of these bumpers are reinforced with an embedded washer or base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines. Install them with screws.

These bumpers are at a 90° angle to protect corners on equipment, walls, and docks from damage caused by carts, vehicles, and other moving objects. Install them with screws.

A ridge on the stem provides a tighter grip than other push-in bumpers. Push the stem into a hole for quick installation. These bumpers are commonly used as feet on instruments and bench-top equipment to keep them from sliding. They're also good as spacers between sheets of material. Also known as stem and grommet bumpers.

Select these bumpers for applications that require specific load capacities. Use them as feet and spacers on instruments and small appliances to limit sliding, vibration, and noise. Press them into place with the adhesive backing. They're comparable to Bumpon bumpers.

Designed to mount at the point of contact between a door handle and the wall, these stops prevent handles from damaging walls when doors swing open.

Protect door knobs and other hardware from damage caused by carts, dollies, and other equipment.

The raised bulb adds cushioning to absorb more impact than other surface guards to protect walls and other flat surfaces from impact.

The guards in this system have a metal core for added strength and stability. Combine corner guards and surface guards to create a system that protects walls and equipment from impact and wear. Often used in warehouse and manufacturing areas, these systems protect against damage from carts and vehicles.

Commonly used in offices, hospitals, and schools, these guards protect corners on walls and other surfaces from impact.

Use this film on metal and plastic parts, appliances, and electronic equipment for protection against damage during packaging, shipping, and installation.

Reduce rattles and squeaks between parts with this abrasionresistant flocked tape. The acrylic adhesive sticks even on hard-to-bond plastics.

Secure two pressurized hydraulic lines with a single clamp to lessen vibration in hydraulic systems. Weld the bottom plate onto the mounting surface for a more secure connection than rail- and adhesive-mount clamps.

For use with a single line, these clamps mount directly onto rails, no adhesive or welding required. They fit tightly around pressurized lines in hydraulic systems to lessen vibration.

These joints are designed for vertical use in drain, waste, and vent systems.