Spend less time on solenoid maintenance in dirty environments—these have a closed steel housing that keeps dust out.

A thin profile allows these solenoids to fit well in narrow spaces.

These solenoid valves operate on electricity to automatically start and stop flow. The actuator is directly mounted to the valve body to minimize movement and reduce wear.

Lower profile and available in smaller connection sizes than standard valves, these fit in tight spots.

Control flow in high-pressure lines in tight spots—these valves have the highest pressure ratings of our compact valves.

Less than half the size of our other compact valves, these have small pipe connections for miniature lines.

These valves are rated for use in hazardous locations with flammable gas and combustible dust.

Built to withstand the extreme cold of liquid nitrogen and liquid oxygen, these valves are cleaned and bagged for high-purity applications.

A built-in strainer traps debris and allows you to replace the screen without disconnecting your pipeline.

For applications sensitive to contamination, these valves stop flow without contacting the process media by pressing down on the outside of tubing.

Insert tubing into the fittings on these valves—no heat, solder, or flux required.

Often used to control single-acting, spring-return air cylinders, these valves have a third threaded port to exhaust media.

Often used for chemical analysis and other laboratory testing, these valves have a PTFE seal and body to withstand aggressive and corrosive solutions. They operate on electricity to automatically divert flow between ports.

These valves create one action, such as extending a cylinder. Apply voltage to the electrical connection to actuate. They're also known as 3/2 valves.

Also known as 3/3 valves, these valves close all ports in the off position to stop equipment in a locked position with air pressure holding it in place. They're often used for vacuum suction and release applications and intermediate cylinder stops.

Run through equipment cycles up to 30% faster than with standard valves. These valves shift between flow positions in 1.7 ms. Often used to extend and then retract a cylinder at different speeds, they create two actions and have two exhaust ports, which allows you to control the speed of each action by attaching a flow control valve to each exhaust port.

In the off position, these valves exhaust all air pressure, allowing the equipment to return to the neutral position. Often used to extend and then retract a cylinder at different speeds, they create two actions and have two exhaust ports, which allows you to control the speed of each action by attaching a flow control valve to each exhaust port. Apply voltage to the electrical connection to actuate.

Create two actions at the same time, such as extending two single-acting cylinders at once. Apply voltage to the electrical connection to actuate. Also known as pressure center valves.

Ceramic plates form a longer-lasting seal against oil and dust than rubber seals that deteriorate over time. These valves withstand use in corrosive, dusty, and dirty environments such as foundries, paper mills, and steel plants. Apply voltage to the electrical connection to actuate.

Rated IP69K, these valves withstand high-pressure, high-temperature washdowns. Their smooth design keeps out dust, dirt, and contaminants, making them easier to keep clean. Apply voltage to the electrical connection to actuate.

Mount valves to a single-station base or to a manifold, which allows a single pressure source for multiple valves, then add or remove valves as your needs change.

Also known as solenoid valves, these valves are operated by an electrical signal to turn airflow on or off.

Set the electronic timer on these drain valves to open automatically at your specified time interval.

Also known as Monday-morning valves, these valves slowly introduce pressure to reduce surge damage during start-up.

Suitable for DC-powered equipment such as forklifts, floor scrubbers, and trucks.