Cut left-hand external threads on bolts, studs, and rods.

Use these dies with Ridgid pipe and conduit threader die heads on Ridgid pipe and conduit threaders.

Each set includes a ratchet with handle, die heads, and dies. Use them to cut NPT threads in steel pipe and conduit by hand.

Use with Ridgid Electric Pipe and Conduit Threaders and Ridgid Hand-Held Electric Pipe and Conduit Threaders to thread pipe and conduit sizes of 2-1/2, 3, 3-1/2, and 4.

Thread, cut, and ream pipe and conduit with these machines.

Add or replace parts such as die sets, power drives, and die head adapters on Ridgid Pipe and Conduit Threaders.

A smaller width than standard hex dies lets you repair threads in tight spaces.

Clamp these dies around your workpiece, so you can start thread repair anywhere along the length of a bolt, stud, or rod. They're hex shaped for use with conventional wrenches.

Renew rusted and damaged pipe and conduit threads.

Clean and restore the fine threads on power transmission shafts that are used with bearing locknuts. Dies are sized according to the American Bearing Manufacturer's Association (ABMA).

Multiple files and handles are included in these sets.

Clamp onto threaded rod, pipe, and conduit from the side to repair threads in tight spaces and where threaded ends are not exposed.

Cut and repair threads and drill holes in many different sizes. Tap and die wrenches are included.

Repair rusted or damaged external threads in a variety of sizes.

Clamp these dies around your workpiece, so you can start thread repair anywhere along the length of a bolt, stud, or rod.

Repair rusted and damaged threads in pipe and conduit. These files are for use in most hole diameters.

With replaceable dies, these long-lasting tools can repair both screw threads and pipe and conduit threads. Use them for holes with an ID from 3/4" to 6".