These transmitters are commonly used to monitor airflow and to indicate when filters in HVAC systems become clogged. They convert the difference in pressure between two points in a low-pressure system into an electrical signal that can be interpreted by receiving devices, such as remote displays, programmable logic controllers, and motor speed controls to monitor pressure or control equipment. Transmitters will only provide accurate readings within the rated pressure range. They come with a calibration certificate traceable to NIST. Maximum pressure is the maximum spike in pressure a transmitter can withstand without damage. Transmitters are accurate only within the pressure range, not up to the maximum pressure. All transmitters are rated IP67 for protection in washdown environments.

These transmitters connect using three wires—two wires into the power supply and a separate wire that sends a voltage signal to the receiver. The receiver and the transmitter share a common ground wire back to the power supply.

Measure the difference in pressure between two process lines in flow applications such as heat exchangers, chillers, and pumps. These transmitters automatically compensate for error introduced by vibration as well as temperature fluctuations, so you do not need to program your receiving device to correct for these factors. Use the keypad to set the pressure range, choose the unit of measure, and zero the transmitter. These transmitters convert differential pressure to an electrical signal that can be interpreted by receiving devices, such as remote displays, programmable logic controllers, and motor speed controls to monitor pressure or control equipment. Transmitters will only provide accurate readings within the rated pressure range. Maximum pressure is the maximum spike in pressure a transmitter can withstand without damage. Transmitters are accurate only within the pressure range, not up to the maximum pressure. All transmitters meet IP66 and NEMA 4X for use in washdown and corrosive environments and have a hastelloy diaphragm to resist harsh chemicals.

These transmitters typically connect using two wires to send a 4-20mA current output. The same wire is used to send a signal to the receiver and to power the transmitter. Current doesn’t lose signal over long distances and isn’t affected by electrical interference from other devices. They can also be configured using three or four wires.

For technical drawings and 3-D models, click on a part number.

For use in hazardous locations, these transmitters safely measure the difference in pressure between two process lines in flow applications—such as heat exchangers, chillers, and pumps. They meet NEC safety standards, so they protect against an explosion where flammable gases and vapors are present.

Automatically compensating for error from temperature fluctuations or vibration, these transmitters don’t require additional programming into your receiving device to correct these factors. Set the pressure range with the keypad, select the unit of measure, and zero the transmitter. They convert differential pressure into an electrical signal that can be interpreted by receiving devices, such as remote displays, programmable logic controllers (PLCs), and motor speed controls, to monitor pressure or control equipment. Transmitters will only provide accurate readings within the rated pressure range. Maximum pressure is the greatest spike in pressure a transmitter can tolerate without damage. Transmitters are accurate only within the pressure range, not up to the maximum pressure. Rated IP66 and NEMA 4X, they protect against dirt, dust, corrosion, weather, and washdowns, and the hastelloy connection protects against harsh chemicals.

Most often, these transmitters connect using two wires to send a 4-20mA current output. The same wire that sends a signal to the receiver also powers the transmitter. Current doesn’t lose signal over long distances and isn’t affected by electrical interference from other devices. Three- and four-wire configurations are also possible.

For technical drawings and 3-D models, click on a part number.