Install a digital readout (DRO) stop and fence system onto the setup for your miter, chop, or radial arm saw. It displays measurements on one axis, allowing you to cut pieces up to 94" with high precision.

Improve the accuracy of your manual milling machine when you retrofit it with one of these digital readout (DRO) systems. They measure and display precise tool positioning on two axes.

Mount one of these digital readout (DRO) systems onto your manual lathe to increase its accuracy. They measure and display precise tool positioning on two axes.

Find the edge of a workpiece, align your setup, and inspect parts with one tool. Once installed in your milling machine spindle, these indicators can measure in three axes.

LCD indicator is IP64 rated for protection from dust and splashing water. It has zero-position memory, also known as absolute (ABS) positioning, which saves the measuring position when the sensor is off. A zero-set button lets you start measuring at any point.

Align guide rails or lay pipe at specific angles from a flat surface. The laser light is red and is best viewed indoors. The display shows the precise angle of the beam and rotates for overhead measurements. The audible level indicator tells you when the tool is level and plumb.

These angle indicators display highly accurate angle, level, and tilt measurements. They come set at true 0°, but you can choose an alternate zero point with the push of a button. Another button will freeze the reading on the display. Indicators have machined leveling surfaces, a V-groove for stability on curved surfaces, and two 6-32 threaded holes for mounting.

Angle indicator with an RS-232 computer connection can be used for ASCII output.

These angle indicators come with a calibration certificate that's traceable to NIST and includes the test measurements that confirm accuracy. The display shows highly accurate angle, level, and tilt measurements. They come set at true 0°, but you can choose an alternate zero point with the push of a button. Another button will freeze the reading on the display. Indicators have machined leveling surfaces, a V-groove for stability on curved surfaces, and two 6-32 threaded holes for mounting.

Angle indicator with an RS-232C computer connection can be used for ASCII output.

With a pressure range common to most compressed air systems, use these transmitters to monitor your system's air pressure. Also known as transducers, these transmitters convert pressure to an electrical signal that can be interpreted by receiving devices such as remote displays and motor speed controls. They can also connect to a programmable logic controller (PLC) with two digital PNP switch outputs, so you can activate automated controls or alarms when a set pressure is reached. They have a digital display with buttons to change settings.

For your receiving device to interpret the signal from the transmitter, you will need to calibrate it for the transmitter's pressure range and output signal. As pressure increases, the output signal from the transmitter will increase. Transmitters will only provide accurate readings within the rated pressure range.

UL and C-UL recognized components, CSA certified, and CE marked, they meet American, Canadian, and European safety standards.

Transmitters with current output connect using two wires. The same wire is used to send a signal to the receiver and to power the transmitter. Current doesn’t lose signal over long distances and isn’t affected by electrical interference from other devices.

Transmitters with voltage output connect using three wires—two wires into the power supply and a separate wire that sends a signal to the receiver. The receiver and the transmitter share a common ground wire back to the power supply.

Add a panel-mounting bracket (sold separately) to mount these switches to a control panel for easy viewing and adjusting.

For technical drawings and 3-D models, click on a part number.