Easily mount these flat switches to a base or rail.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

Eliminate the need to calculate the sensing distance when using different metals—these switches sense all metal at the same distance. Also known as K=1 sensors.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

These intrinsically safe switches detect objects as they’re routed through the ring. They produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks. Switches are ATEX certified to protect against explosion.

These switches have a longer sensing distance compared to other proximity switches with the same diameter.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

Set these switches to delay activation by up to five seconds after detecting an object.

For optimal performance in tight spaces, these switches have a smaller beam and can detect smaller objects than standard photoelectric switches.

Safely detect the presence or absence of an object moving at high speeds with a light beam. These switches produce a low-current, low-voltage NAMUR signal, so they won’t create sparks or ignite. ATEX and IECEx certified, they protect against explosion in environments containing flammable gases and combustible dust.

Prevent unauthorized use—these switches require coded magnets to actuate. They cannot be bypassed using ordinary magnets.

Use a laser to determine the distance to an object up to 700 yards away.

Record steps or miles while you walk or run.

Slide this ruler across the surface of plans, maps, and blueprints and read the measurement on the digital display in one of 111 different scales including inches, feet, yards, miles, centimeters, meters, kilometers, or a scale you define.

Navigate on foot with real-time GPS data.

This switch mounts to the outside of your tank and detects chemical level through plastic tank walls by measuring the capacitance between the switch and tank contents; it cannot be used with metal tanks.

Detect when oil rises on water, foam forms on beer, and tanks empty, triggering pumps and valves in food and sanitary lines. These switches are 3-A and European Hygienic Engineering and Design Group (EHEDG) certified since they’re easy to keep clean.

Short probes are built into the tip of these switches.

Cut the probes on these switches to fit the size of your tank.

Clamp around sensors and switches for a secure hold.

The spring-loaded design absorbs impact to protect sensors and switches from damage.