Search Results
    Cut Direction
    Cut Direction
    Right Hand
    Left Hand
    Neutral
    Shank Width
    Shank Width
    3/4"
    1"
    For Insert Code
    For Insert Code
    DNMG-431
    DNMG-432
    DNMG-332
    Holder Code
    Holder Code
    MDJN
    DDJN
    MDPN
    Shank Height
    Shank Height
    3/4"
    1"
    For Insert Inscribed Circle Diameter (IC)
    For Insert Inscribed
    Circle Diameter (IC)
    default
    3/8"
    1/2"
    Insert Holding Method
    Insert Holding Method
    Clamp with Lock Pin Screw
    Wedge Clamp
    Overall Length
    Overall Length
    4 1/2"
    6"
    Clamp Screw Hex Key Size
    Clamp Screw Hex Key Size
    3/32"
    5/32"
    Clamp Screw Reference Number
    Clamp Screw
    Reference Number
    XNS-48
    XNS-36
    XNS-510
    Seat Reference Number
    Seat Reference Number
    IDSN-433
    IDSN-322
    IDSN-443
    Clamp Reference Number
    Clamp Reference Number
    CL-20
    CL-7
    CM234R ASSY
    CL-12
    Side Rake Angle
    Side Rake Angle
    default
    -7°
    -5°
    Back Rake Angle
    Back Rake Angle
    default
    -9°
    -7°
    -5°
    End Relief Angle
    End Relief Angle
    default
    Side Cutting Edge Angle
    Side Cutting Edge Angle
    default
    27.5°
    -3°
    Side Relief Angle
    Side Relief Angle
    default
    Shank Style
    Shank Style
    Offset
    Straight
    Seat Screw Reference Number
    Seat Screw
    Reference Number
    KMSP415IP
    KMSP315IP
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    35 Products