Step on the spring-operated plunger to hold your door in place; tap on the release lever to free it.

Small enough to slip into a pocket, these foldable wedges are good for workers who frequently need to prop doors open as they move from job to job. Slide them under the door to hold it open.

These three-way holders can be inserted under the door, over the top corner of the door, or over the hinge pin to hold a door open.

A magnet holds the door open; pull on the door to release.

Latch your door to the wall for a secure hold.

For use with doors that already have a closer, these holders keep doors open with an electromagnet. When activated by a fire alarm, the magnet shuts off and releases the door.

Place one of these wire springs onto your door's hinge pin to keep it open.

These closers include a door holder, which keeps doors open with an electromagnet. When activated by a fire alarm, the magnet shuts off and releases the door.

When used in pairs, these supports can hold lids weighing over 200 lbs., which is three times more than our other lid supports. Manually control these free-moving lid supports through their full range of motion. Raise the lid until the hold-open mechanism on the support is engaged; slightly lift it again to release the hold and close the lid.

No separate hinges are required, these supports act as a hinge and lid support all in one. Springs provide lifting assistance to raise and hold lids open—slightly lift the lid to get it started and the support will do the rest. Manually shut the lids and the supports will hold them in the closed position.

Gradually slow your lid's motion to prevent it from slamming open. To open lids, lower them and the support will slowly and softly do the rest. Manually shut the lids and the supports will hold them in the closed position.

Mechanical operation means these springs have no seals to fail or gas to leak.

A temperature-resistant seal allows these gas springs to withstand heat up to 392°F.

Made from stainless steel for excellent corrosion resistance in damp environments.

Ensure you have the correct force for your application. These gas springs have a bleed valve so you can release gas to permanently reduce the force to meet your requirements.

Release gas from these springs until they supply the exact force you need—made of corrosion-resistant 316 stainless steel, they’re commonly used in wet environments.

Ensure you have the correct force for your application. These gas springs have a bleed valve so you can release gas to permanently reduce the force to meet your requirements.

Made from stainless steel for excellent corrosion resistance in damp environments.

Small in size, but not in strength, these gas springs are often used to replace coil springs in metal stamping and die-spring applications.

Attach eyelet end fittings to these brackets to mount gas springs.

Made from stainless steel for excellent corrosion resistance in damp environments.